Re-attachment of the white sensor roller, Iroller cleaning paper, Roller cleaning paper – Panasonic KVS2055L User Manual

Page 34: Cleaning the unit

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Cleaning the Unit

Re-attachment of the white sensor roller

When the white sensor roller is removed while cleaning the inside of the scanner, re­
attach it as shown below.

Lower white sensor roller:

Attach the roller by placing the gear
side to the left side of the scanner
and inserting both side's bearings

into the guide grooves.

After

attaching,

press

down

on

top

of

the

white

sensor

roller

with

your

finger

to confirm if it moves or not.

Upper white sensor roller:

©Attach the roller by inserting the

bearing of the gear side of the

roller into the guide groove on the

left side of the scanner.

• Match the flat side of the bearing with

the flat side of the guide groove.

©Hold the shaft on the right side of

the white sensor roller, push the

tip of the gear, and slide the white

sensor roller in the direction of the
arrow

Then attach the roller by inserting
the bearing of the non-gear side of
the roller into the guide groove on
the right side of the scanner.

• Match the flat side of the bearing with

the flat side of the guide groove.

IRoller cleaning paper

Open the bag on the dotted line and

take out the roller cleaning paper.

• If the bag is left open for a long period

of time, the alcohol will evaporate.

Please

use

the

roller

cleaning

paper

immediately after opening the bag.

^*The roller cleaning paper (Model No. KV-SS03) is available from the dealer where

you purchased your scanner.

For supplies and accessories: Call 1-800-346-4768 (U. S. A. only) or your dealer.

34

Advertising