Panasonic TX-29F155A - Manual (Page 11)

( Picture menu )
Colour temperature Allow you to set the overall colour tone of the
picture.
Press or QT) to switch between modes.
c
Cool- •Standard" Warm
P icture menu 1
Menj Dynamic
C o n t r a s t - -- -- -- -- -- -
B r i g h t n e s s -------
C o l o u r -------
Sharpr^ess ------------
NTSC'-Tifit
|ilii!l rtii I »TlnffiTninTil C. 0 0
P-NR
{Picture Noise
Reduction)
Automatically reduces unwanted picture noise.
Press or 03 to switch between modes.
P icture menu
c
Off •
Auto-
■ Weak
> Strong
a
Scan mode Lets you choose the screen refresh method:
Press (33 or C3 to switch between modes.
[!
Auto-
loom
■ Progressive
!]
Picture mertti
P - M R
Mode Function
Auto The TV software will select the best mode for the signal being
viewed.
100Hz 100Hz will give a steady picture for most signal transmission.
Progressive Recommended when receiving NTSC signals.
Note:
We recommend that you set Scan mode to Progressive when viewing a PAL 60 or
NTSC transmission. When viewing a PAL transmission (other than PAL 60) with Scan
mode set to Progressive, the screen will flicker, this is not a fauft.
■'i>- Helpful Hint ( ® Normalization)
By pressing the Normal “N" button on the Remote Control while the Picture menu is displayed, the selected menu
wilt be changed to the Normal mode.
Normalization will not occur if the menu is not displayed when the “N" button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.
11