Recording frain radio broadcasts, Fif eaco-sil, Recording from radio broadcasts – Panasonic SC-CH75 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Recording frain radio broadcasts

6

Advance the leader tape a few revolutions.

1

2

DECK 2

Press ^ OPEN on deck 2, and

then insert the tape.

Close the holder.

When making a Dolby NR re­
cording, press DOLBY NR so
that the Dolby NR indicator

lights.

Fif eaco-sil

Press REV MODE to select the
reverse mode.

T — O n e side will record, and then the

tape will stop automatically at the
tape end.

Zly. Both sides will record (forward

side—»-reverse side), and then the
tape will stop automatically at the
tape end.

cZy>‘- Same as above. (When you press

REC START/STOP, “cr::)’’ will be

automatically switched over to

DECK1/2

Press TAPE, DECK 1/2 to se-
lect “DECK 2”.

I

I

I ^

J

^ 1 1 WMCV J

Press or immediately fol­
lowed by

■.

b

This selects which direction the tape runs

in. ^

'4'

► :

Recording from forward side

Recording onto reverse side

Press TUNER, BAND to select
“FM”, "MW” or “LW”.

fpor Australia and New Zealand |

Note that for Australia and New
Zealand, there are two bands of “FM”,

“AM” instead of “FM”, “MW”, “LW".

Press TUNING MODE to select
"PRESET".

You can also select the desired broad*
cast station by tuning manually.
(See page 11.)

8

Press V or A to select the pre-

set chsnnel.

STOP

STAHT/STOP

Press REC START/STOP to

start recording.

JJJJ

JJJJ

ranm iSinetw

C M

Q Q

I ■ ;

r I I o U. I u .

To stop recording

Press REC START/STOP again.
Recording can also be stopped by pressing ■.

To cut an unnecessary part while recording

1. Press REC STAHT/STOP when hearing a unnecessary part.

The cassette deck will go into the stop mode.

2. Press REC START/STOP when wanting resume recording again.

Recording will continue in the same direction as before.

To reduce the noise while LW/MW

recording (Beatproof function)

While in the recording mode of LW/MW (For Australia and New
Zealand: AM) band;

Press FM MODE/BP while re­
cording.

Each time you press the button, BP 1, BP 2 and BP 3 will be dis­

played alternately. (For Australia and New Zealand: BP 1 and BP 2
will be displayed alternately and “AM" display appears instead of
“MW".)
Select the position where there is less noise.

Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may

infringe copyright laws.

Advertising
This manual is related to the following products: