Panasonic SC-CH75 - Manual (Page 27)

Select the desired source and
then prepare the stereo for
play.
When you play CD(s):
Press CD and insert CD(s).
Stop the CD(s) after playback.
When you play tape(s):
Press TAPE, DECK 1/2 and insert
tape(s).
Stop the tape deck after you select the
direction of the tape.
When you play the radio:
Press TUNER, BAND and tune in the
desired station.
When you play a unit connected to the
"AUX” terminals:
Press AUX.
Set the playback volume.
HPLAY
Press S PLAY.
The unit will be switched to the power
standby condition.
The timer play will start at the preset time
with volume increasing gradually up to
the volume level you preset.
To switch the timer OFF
Press Q PLAY and check “Q PLAY” goes out.
The settings made with the preceding procedure will however be kept
in memory.
To check settings (only while power is ON)
Press CLOCK/TIMER 3 times and check “E] PLAY" is displayed.
(T) Play start time
@ Play over time
@ Play source and playback volume
To change settings (only while power is ON)
© Press □ PLAY and check “[g PLAY" goes out.
d) Reprogram from step 1.
Using the timer at the same time setting continu­
ously
{You can accomplish this even if your stereo is on standby.)
The settings made with the preceding procedure will however be kept
in memory.
Press eg PLAY and check “[g PLAY" is displayed.
To enjoy the desired source after the timer setting
is completed
1. After finishing step 6, switch on the power and, start playing the
desired source.
Even if you change the volume level or music source, the timer
play will start with the preset condition.
2. Press POWER to standby mode after enjoying the play, and
confirm CD(s) ortape{s) has (have) been inserted.
• if the power is on, the timer will not function. The system must be in
the standby mode.
•The ON time and OFF time cannot be the same setting.
• If you switch the power to the standby mode while the play timer is
functioning, the OFF time setting will not be activated,
• The lowest possible volume with the timer is -60 dB. If you set it
lower than this, it will automatically be played back at -60 dB just
the same.
• Record timer cannot be used in combination with the play timer.
For your reference
• External sources must be connected to the “AUX" terminal. How­
ever, time settings apply only to this stereo. For more information,
see the instruction manual of the connected unit.
• As long as "Cg PLAY" is displayed, the timer will work every day at
the same time.
• When you insert cassettes in both deck 1 and 2, deck 2 has priority.
27