Panasonic PALMLINK KX-TR320B - Manual (Page 5)

To Communicate Section 3
3-D Call Tones
The unit has five different call tones to identify each user and alert
others that you intend to transmit. When you press
(CALL), the
other party will be alerted with your call tones.
To send call tones
O Press [CALL].
•The TALK/BUSY indicator lights red.
•“CALL” is displayed and the call tones sound.
•The other party will be alerted with the call tones.
• The call tones will sound continuously if you press and hold
fCAiXl.
• If you want to send the call tones privately, open the flip before
pressing [CALL],
To change the call tones
The factory preset is “1”.
0 Press four times.
•“CALL” and the current setting will flash
on the display.
0 Press (3 or El repeatedly until the
desired setting (1-5) is displayed.
• Each time you press the button, the
selected call tones will sound.
f—
/ C4Lt'
)
CAIL
----4«-
__J
o When finished, press [ talk ] or w/ait for 10 seconds.
3-E Vibratory Call
( kx - tb 325 only) |
KX-TR325 allows you to receive a vibratory call instead of a
message or call tones (—“Vibe Ringer”). This is useful in noisy
locations, or when quiet is required. The factory preset is OFF,
To turn on/off the vibratory call mode
O Press [M^U] five times.
•“VIB" and the current setting will flash on
the display.
0 Press (E) or E] fo turn on/off the
vibratory call mode.
^ V7i
oF,
\__
■1^'
K__
e When finished, press [TALK] or wait for
10 seconds.
•When set to ON, “VIB” will remain on the display.
When you receive a vibratory call
The unit vibrates while the other party is sending a message or call
tones.
—To hear the other party, press [ MONITOR ].
—To transmit, press and hold [TALK] or open the flip, and talk into
the microphone.
The vibratory call mode is temporarily turned off during transmission.
30 seconds after transmission is complete, the unit will return to the
vibratory call mode.
• The vibratory call mode is turned off while the flip is opened. When
you close the flip, the unit will return to the vibratory call mode.