Panasonic MC-V5715 - Manual (Page 12)

5. Reinsert the tab pro
vided on the end of the
dust cover into the
grooves on the dust
compartment to allow
the cover to rotate
ciosed.
NOTE: The dust
cover must be
completely and
correctly
installed for
proper
operation.
6. Rotate the dust cover up into
the closed position and press
into place.
NOTE: The dust
bag should not
be caught
between the
lower edge of
the dust cover and
the gasket as indicat­
ed by the arrow in
the illustration.
CLEANII
.
:CX)NDARY FOAM RLTER
A secondary foam filter protects the
motor from dirt. When installing a new
dust bag, check this filter. Accumulated
dirt in the dust compartment will collect
on the filter and may restrict motor per­
formance. When the filter becomes
dirty, pull it from the bottom of the dust
compartment and clean by rinsing with
water. When dry, slide the filter back
into place, insert the secondary foam
filter with a ruler or something flat, it
should be fully inserted under the plas­
tic rib projections all the way to the
rear.
^ S:«*: * X
REPLAaNQ ELECTROSTATIC EXHAUST RLTER
■
The Electrostatic exhaust filter is located inside the dust
cover. The purpose of this filter is to remove dust and dirt
from the recirculated air. When installing a new dust bag,
check ttiis filter. When the filter becomes dirty, remove it
from the bottom of the dust cover by pulling it straight
up. Replace the filter.
DO NOT CLEAN WITH
WATER*. Place the new filter back into the dust
cover with the six (6) slots in the filter aligned with
the six tabs on the dust cover, and making sure
the rough side is facing up.
*This filter cannot be cleaned and should
be replaced at least once each year if the
cleaner is used at least one hour each week.
£jr/)austF/№r
(Electrostatic)
Dust Cover
-
1 2 -