Seymour Midwest Topping & Underlayment Squeegee(PK90434) - Manual

Topping & Underlayment Squeegee
Assembly Instructions
PK90434
01/21/15
Parts Shipped with Unit:
- Head
- Threaded handle adapter or aluminum handle (not pictured)
- Gusset brace (set of 2) – one gusset is labeled if unit comes with
threaded handle adapter
- Bolt bag for brace
- Rubber blade (one square edge, one rounded edge)
Mailing Address: Shipping Address:
P.O. Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
Tools Needed for Assembly:
- 7/16” wrench (two)
Rubber Blade Installation Instructions:
1.
Loosen nuts (do not remove) on head and insert square edge of rubber
blade.
2. Rest other edge of rubber blade on a hard, flat surface (as shown) and
adjust blade to ensure the square edge is seated straight in the head and
level with the flat surface.
3. Tighten nuts until rubber blade is secure, being careful not to over tighten.
NOTE: It is important when installing or replacing the rubber blade that it be
installed straight.
Gusset Brace Instructions:
1.
Slide slotted handle or threaded handle adapter over the center hole on the
aluminum frame. (wing nuts on frame should be facing up)
2. Position one gusset on bottom of adapter, as shown, and the other gusset
on top of the adapter.
3. Insert the two longest bolts through the top gusset, the handle or adapter,
and the bottom gusset. Insert the two shortest bolts through the two
remaining holes.
4. Tighten all nuts being careful not to over tighten. Over tightening hardware
may result in crushing the handle, thereby compromising its strength.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com