Seymour Midwest Wire Gauge Rake(PK90113) - Manual

Wire Gauge Rake
Assembly Instructions
Tools Needed for Assembly:
7/16” wrench (two)
Parts Shipped with Unit:
Head assembly (3 wires and hardware included)
Threaded handle adapter or aluminum handle (not pictured)
Gusset brace (set of 2 – one gusset is labeled)
Bolt bag for braces
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center
hole on the aluminum frame.
2. Position labeled gusset on bottom of handle/adapter, and the other
gusset on top of the handle/adapter as shown.
3. Insert the two longest bolts through the top gusset, the
handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.
4. Tighten all nuts, being careful not to over-tighten. Over-tightening
hardware may result in crushing the handle, thereby compromising
its strength.
PK90113
01/21/15
To Adjust Coating Thickness:
1. Loosen all six wing nuts (B).
2. Slide gate (A) up or down to desired depth (C) and tighten two
outside wing nuts.
3. Check setting (C) again and tighten remaining wing nuts before
using.
Note: This unit has been assembled at the factory for 0” to 3/8” thickness. To
obtain 13/32” to 5/8” maximum thickness, gate (A) should be removed and
turned upside down then re-installed as the adjustment slot is offset to one side.
REPLACEMENT PARTS LIST
See Reverse Side
Mailing Address: Shipping Address:
P.O. Box 1674 2666 S. Country Club Rd.
Warsaw, IN 46581-1674 Warsaw, IN 46580
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com