Softride 26496 Hang5 bike rack (New) - Manual

HANG5 RACK INSTRUCTIONS
Model #26496
Important This bike rack is designed to carry a maximum of 5 bikes and is intended to be used ONLY with a 2” receiver hitch.
Do not use this rack for anything other than carrying bicycles on a passenger vehicle.
Do not exceed your vehicles load ratings for any reason.
This rack cannot be used on vehicles with a 1.25” hitch.
Reference the instruction manual for proper use of this rack.
DO NOT use any aftermarket extenders or adapters with this rack.
Check the tightness of bolts and nuts periodically as they may loosen slightly during normal use.
DO NOT drive the vehicle with the bike rack loaded in the Parallelogram Lowered position.
This rack CANNOT be mounted and used on the rear of trailers or RVs.
Remove this rack from the vehicle before going through a car wash.
Warning
PARTS INCLUDED
TOOLS REQUIRED
Metric Allen Wrench (5mm)
2 Adjustable Crescent Wrenches
13 mm Socket Wrench w Extension (2-3”) Metric Socket Set
7/8” Ratcheting Box Wrench (See Fig. 10)
13mm Wrench
Torque Wrench up to 60 ft-lbs
RECOMMENDED ASSEMBLY TOOLS
(1A) Main Base Rack Assembly
(1B) Top Plate
(1C) Carriage Bolt, Nut and Washer x4
(1D) 5/8” Hitch Bolt and Lock Washer
(1E) Hitch Lock (p/n 25056)
(1A)
(1B)
(1C) x 4
(1D)
(1E)
BOX 1
Lower Support Bars x2
Rear Wheel Support Bar (longer)
Rear Wheel Support Bar (shorter)
Rubber Straps (14 hole) x 10
8mm x50mm Bolt, Nut, 2 Washers x4
10mm x 65mm Bolt, Nut, 2 Washers x6
8mm x 65mm Bolt, Nut, 2 Washers x16
(ships with 10 of 16 pre-installed)
8mm Button Head Bolt, Nut, Washer x4
(5mm hex wrench required)
(1F)
(1G)
(1H)
(1I)
(1J)
(1K)
(1L)
(1M)
(1F) x 2
(1G)
(1H)
(1I)
(1J) x 4 (1K) x 6
(1L) x 16
(1M) x 4
(Access Rack)
(Hang5 Rack)
1