Cisco 1805 - Manual

C H A P T E R
6-1
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
6
Power-Up Procedures for Cisco 1805 DOCSIS
Cable Routers
This document describes how to power up Cisco 1805 DOCSIS cable routers and perform an initial
configuration to provide network access. It includes the following sections:
Powering Up Cisco 1805 Cable Router, page 6-1
Verifying the LED Indicators, page 6-3
Verifying the Hardware Configuration, page 6-3
Initial Configuration of the Router, page 6-4
Note Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for Cisco 1840 Routers for important safety information and translations of the warnings
that appear in this guide.
Powering Up Cisco 1805 Cable Router
Warning The plug-socket combination must be accessible at all times because it serves as the main
disconnecting device. Statement 1019
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029.
Caution To ensure adequate cooling, never operate the router unless the unit is completely closed.
This section covers the following topics:
• Checklist for Power Up, page 6-2
• Power-Up Procedure, page 6-2