Columbia House 4200 - Manual

Toilet Support Instructions
Models #4200, 4300, 4400 (Lo-Back)
4600, 4700, 4800, 4900 (Hi-Back)
Thank you for Choosing Columbia
Your Columbia Toilet Support has been built to the highest standards of quality to ensure years of superior
service. Please take the time to read this informative instruction guide and pay particular attention to the
safety instructions provided. Thank you again for choosing Columbia!
Important Safety Instructions
When using your Toilet Support, basic safety precautions should always be followed to reduce the risk of
injury to persons.
1. Read and understand all instructions.
2. Determine, with a physician or therapist, the suitability of this support for the intended user.
3. Users with limited physical capabilities should be supervised or assisted when using this product.
4. Check that all locking knobs, buckles, and other parts are tight at all times.
Save These Instructions
Installing your Toilet Support
Step 1: Remove your Toilet Seat
Remove your toilet seat from your toilet bowl. This is done by
unscrewing the nuts on the two bolts that hold your seat onto
your toilet bowl. If the bolts are rusted, you may need to use
new nuts and bolts when you replace your toilet seat.
(See Fig. 1)
Step 2: Mount the Base Plate
Set the base plate directly on your toilet bowl, as in Figure 1, so
the holes in the plate line up with those in your toilet bowl. Note:
you have a choice of using the front or rear pair of holes in the
plate. You may need to use the rear pair in order to clear the
water tank on your toilet. Otherwise you may use your choice of
holes, to position the support more forward or rearward,
depending on the seat depth that would be most comfortable for the user of the support.
Replace your toilet seat, on top of the base plate, so the two bolts you removed in Step 1 go through the
holes in the plate as well as into the holes in your toilet bowl. Tighten the nuts firmly on the two bolts.
C0420-00-01 Updated: 8/23/07 1