Adaptive Technologies 2X2-X551-VWD User Manual
Hovertrack
© 2011 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.01-08/11
2 Wide x 2 Deep Video Wall Display (Rear View)
2 Wide x 2 Deep Video Wall Display (Surface Mounted)
HoverTrack
®
Series
2X2-X551-VWD
2 wide x 2 deep Video Wall Display Installation Guide
This display kit mounts NEC X551UN LCD monitors in
a 2 wide by 2 deep landscape configuration. The frame
attaches to a wall and receives the LCD monitors by
way of four machined fittings (per monitor) that thread
into the monitor’s VESA holes. These fittings then
insert into the frame’s channels. The monitor’s fittings
secure to the frame with locking arms that provide an
easy way to remove the monitors for service. A
removable panel provides access for media players
behind the frame.
Important: Installing video displays is a serious
endeavor that requires experienced professionals.
Improperly prepared walls and other structures as
well as the equipment being installed can result in
property damage, injury and/or liability to the
installing contractor. Do not proceed if any part of
the installation is in doubt.
Caution: Due to the wide variety of structures,
environments, materials and installation methods, the
installing contractor must exercise good judgment in
selecting the proper mounting area. The mounting
structure must be capable of supporting at least 5
times the load of the installed equipment. Consult local
building codes for further guidance.
Follow these instructions for the most efficient
and safest mounting results.
Package Contents:
1 pc
2x2 Frame w/ locking arms bracket
16 pcs Phillips flat head screw, M6-25mm long
16 pcs Upper-lower stand-off button (black)
16 pcs Nylon washer spacers, .28IDx .74OD, white
1 pc
Instruction sheet
Notes:
Hardware to mount frame to the wall are not included
Recommended:
Install at least 3 /4” thick plywood to achieve flatness of the wall for installation and to provide an adequate support for the video display.
Note:
The assembled 2x2 frame weighs approximately 80 lb/36.4 Kg and requires at least two installers during lifting.