Adaptive Technologies 2X4-UE46A-VWD User Manual

2x4-ue46a -vwd, Assembly installation guide

Advertising
background image

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-02/18/13

Upper Frame (Figure 1)

2X4-UE46A -VWD

Assembly Installation Guide

Important: Assembling video displays is a serious endeavor that requires
experienced professionals. Improperly assembled equipment can result in
property damage, injury and/or liability to the installing contractor.
Do not
attempt to install this equipment if any part of the assembly is in doubt.

Follow these instructions for the most efficient and safest assemble results.

Do not attempt to install this product if any of the parts listed below are

missing. If parts are missing, contact [email protected];

Package Contents:
8 pcs

9-0676 2X H-Slat

3 pcs

9-0678 2X V-Channel Assy.

3 pcs

9-0640 2x lower v-channel assy.

8 pcs

9-0696 Lock Arm Bracket w/ hrdwr

3 pcs

9-0644 vertical Joiner plate

32 pcs M8 adjustable VESA buttons (long shaft)
1 pc

Adjustment wrench

18 pcs Adjustable Wood screw Hanger stud
108 pcs Flat head phil. Screw, M6x20mm long

Step 1: Assemble Upper Frame
Place all of the parts in figure 1 on the floor. Start with three 9-0678 2X V-
channels with their open side facing up and with the narrow part of the key
holes slots facing up in all in the same direction.
Place four 9-0676 H-Slats over the 2X V-channels
with the keyhole surface facing up and the four-hole
patterns lining up with that of the V-channels (Figure
1).
Rectangular slots in the ends of the H-slats should
be at the outer edge of the frame. (See figure 4).

Step 2: Assemble Lower Frame:
Place all of the parts in figure 2 on the floor. Start
with three 9-0640 2X Lower V-channels with their
open side facing up with the narrow part of the key
holes slots facing up and all in the same direction.
Place four 9-0676 2X H-Slats over the 4X lower V-
channels with the keyhole surface facing up and the
four-hole patterns lining up with that of the channels
(Figure 2).
Rectangular slots in the ends of the slats
should be at the outer edge of the frame. (See figure

4).

Advertising