Adaptive Technologies 4X2-X462-4X-FS User Manual

Hovertrack

Advertising
background image

© 2012 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-01/12

4X2-X462-VWD Video Wall on a Floor Stand

HoverTrack

®

Series

4X2-X462-4X-FS

Assembly Installation Guide

4 Wide Video Wall Floor Stand

This video wall floor stand display the NEC X461 and
X462 monitors in a 4 wide by 2 deep or 4 wide x 3 deep
landscape configuration. The video frame easily attaches to
vertical column by way of bolts and nuts. The floor stand
comes with adjustable feet to compensate for any
unleveled flooring.

Important: Installing video displays is a serious endeavor
that requires experienced professionals. Improperly

assembled floor stands and other structures as well as

the equipment being installed can result in property

damage, injury, death and/or liability to the installing
contractor.
Do not proceed if any part of the installation is
in doubt.

Caution:
Due to the wide variety of structures,
environments, materials and installation methods, the
installing contractor must exercise good judgment in
selecting the proper area. The base structure must be flat
and capable of supporting the height of the video wall
display. Consult local building codes for further guidance.

Follow these instructions for the most efficient and

safest mounting results.

Package Contents:
3 pcs

4X2-X462-4X-FS-A Vertical column Assembly

8 pcs

4X2-X462-4X-FS-B Horizontal Brace Assembly

6 pcs Adjustable leveler foot, ½-13 thread
13 pcs Hex bolt, 3/8-16 x 5” long, black
48 pcs Hex bolt, 3/8-16 x 3.25” long, black
122 pcs Flat washer, 3/8 SAE,black
61 pcs Nyloc nut, 3/8-16, black
6 pcs

End cap, 2 x4, black

Step 1:
Before starting assembly, check included parts list to make
sure all hardware are accounted for.

Step 2:
Attach the end caps to both ends of the base tubes (Figure 1).

Step 3:
Screw in the Adjustable leveler foot into the two weld nut under the base tube (Figure 1).

Step 4:
Connect two horizontal brace’s plates to the bottom side of the right vertical columns using the provided 3/8-16 x 3.25” long hex bolt, flat
washer and nuts. Snugly tighten bolts (Figure 2).

Advertising