Brookfield DV2T Viscometer User Manual

Page 14

Advertising
background image

Brookfield Engineering Labs., Inc.

Page 14

Manual No. M13-167-B0614

Figure II-2

The operator must ensure that the viscometer is level (see Section I.4) and remove any

attached spindle or coupling. When the Next button is pressed, the viscometer will operate

for approximately 13 seconds. After the AutoZero is complete and the operator presses

the Next button, the viscometer will transition to the Configure Viscosity Test screen. If

the AutoZero was performed from the Settings Menu, then the viscometer will return to

the Settings Menu.

TIP: Do not touch the viscometer during the AutoZero process to ensure the best zero

value.

II.3 Status Bar

The DV2T Viscometer will display a status bar at the top of the screen at all times.

This status bar will indicate: time of day, date, and connection status for a variety of

connection devices. The status icons are defined as:

USB Icon 1,2,3: The DV2T Viscometer can store data and tests to USB

storage device (USB B) such as a USB Flash Drive.

There are three USB ports. These ports are represented

as 1, 2 and 3 based on the order of connection.

Printer Icon:

The DV2T Viscometer can communicate to a label printer

for printing test results (see Section II.8).

Computer Icon: The DV2T Viscometer can communicate with a computer

through the USB A port. Communication is supported

with Brookfield RheocalcT software.

Advertising