California Faucets Wall Tub Spout User Manual

Solimar, Ts-70-70 wall tub spout installation instructions

Advertising
background image

TS-70-70_ii_120119.doc

Pg

1

Solimar

TS-70-70

Wall Tub Spout

Installation Instructions

1



IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:

Recommended Supply Pressure:

20 to 70 psi

Flow

Rate

(at

60

psi):

10

gpm

If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).


INSTALLING SPOUT

• Prior to installing spout in-wall fittings and rough

valve must be properly installed and wall surface

must be completely finished

• Recommended through-hole size shall be Ø1-1/4”

• Apply thread sealant to both threaded ends of

NIPPLE (2), not supplied, and tighten into
supported ELBOW (1)

,

not supplied

IMPORTANT: QUICK CONNECT (3) must sit inside wall 5/8” min
to 1” max, to properly secured SPOUT (6) to QUICK CONNECT

(3). This may be achieved by selecting proper NIPPLE (2) length.

• Securely tighten QUICK CONNECT (3) onto end

of NIPPLE (2) using I/2” open-end wrench

• Place O-RING (4) into ESCUTCHEON (5) & slide

ESCUTCHEON (5) onto QUICK CONNECT (3)

IMPORTANT: To prevent damage to internal o-ring on SPOUT
(6), QUICK CONNECT (3) must be free of any dirt and/or debris

• Slide SPOUT (6) onto QUICK CONNECT (3),

align ESCUTCHEON (5) & SPOUT (6) and tighten

SETSCREW (7) on bottom side of SPOUT (6)





CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

Ø

1-1/4”

Must sit inside wall
5/8” min to 1” max

Advertising