COP-USA CM260IR-IP - Manual (Page 22)

Page 18 2 Mega Pixel IP Camera User Manual
2. Input the protocol, address and baud rate according to the speed dome.
5.3.2
Preset Configuration
1. Go to “PTZ Configuration”
Æ “Preset” to see an interface as shown below:
Button Meanings
to rotate the dome upwards; to rotate the dome downwards;
to rotate the dome towards left; to rotate the dome towards right;
to stop rotating the dome.
Focus button. Click button to have long focus; click button
to have short focus.
Zoom button. Click button to zoom in the locale picture ; click
button to zoom out the locale picture.
Iris button. Click button to increase light of the dome; click
button to decrease the light of the dome.
Drag the scroll bar to adjust rotating speed of the dome.
2. Input the preset number and set its position by controlling PTZ control panel and then click
Add button to add preset point into the Available position list.
3. Select the preset in the pull down list of the Available position and click Go to button to
move the dome to this preset point; click Delete button to delete checked preset point.
4. After finishing setting, click Save button to save the settings.