Cisco OL-21636-01 - Manual (Page 77)

4-19
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 4 Managing a FlexUNI/EVC Ethernet Service Request
Setting the Service Request Details
If this check box is unchecked, you are prompted to specify a bridge domain name during service request
creation (see the next step).
Usage notes:
• The AutoPick Bridge Domain Name attribute appears only for Cisco ASR 9000 devices.
• The AutoPick Bridge Domain Name attribute only appears if Configure Bridge Domain was enabled
in the EVC Service Request Editor window earlier in the service request workflow.
Step 35 If the AutoPick Bridge Domain Name check box is unchecked, enter a bridge domain name in the Bridge
Domain Name text field.
Usage notes:
• Bridge Domain Name field appears only for Cisco ASR 9000 devices.
• The Bridge Domain Name attribute only appears if Configure Bridge Domain was enabled in the
EVC Service Request Editor window earlier in the service request workflow.
Step 36 Check the Use PseudoWireClass check box to enable the selection of a pseudowire class.
This attribute is unchecked by default.
Usage notes:
• The pseudowire class name is used for provisioning pw-class commands on IOS XR devices. See
Creating and Modifying Pseudowire Classes for IOS XR Devices, page 2-10 for additional
information on pseudowire class support for IOS XR devices.
• If Use PseudoWireClass is checked, an additional attribute, PseudoWireClass, appears in the GUI.
Click the Select button of PseudoWireClass attribute to choose a pseudowire class previously
created in ISC.
• The Use PseudoWireClass attribute is only available if the MPLS core connectivity type was set as
PSEUDOWIRE in the Service Options window (see
Setting the Service Options, page 3-8 ).
• Use PseudoWireClass is only applicable for IOS XR devices.
• The Use PseudoWireClass and PseudoWireClass attributes only appear if Configure Bridge Domain
was not enabled in the EVC Service Request Editor window earlier in the service request workflow.
Step 37 For L2VPN Group Name choose one of the following from the drop-down list:
• ISC
• VPNSC
Usage notes:
• This attribute is used for provisioning the L2VPN group name on IOS XR devices.
Note The choices in the drop-down list are derived from a configurable DCPL property. For
information about how to define the L2VPN Group Name choices available in the
drop-down list, see
Defining L2VPN Group Names for IOS XR Devices, page 2-14 .
• The L2VPN Group Name attribute is not available if the MPLS core connectivity type was set as
VPLS in the Service Options window (see
Setting the Service Options, page 3-8 ).
• L2VPN Group Name is only applicable for IOS XR devices.
• The L2VPN Group Name attribute only appears if Configure Bridge Domain was not enabled in the
EVC Service Request Editor window earlier in the service request workflow.
Step 38 Enter an E-Line Name to specify the point-to-point (p2p) E-line name.