Setting the service options, Figure 3-2 – Cisco OL-21636-01 User Manual

Page 42

Advertising
background image

3-8

Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0

OL-21636-01

Chapter 3 Creating a FlexUNI/EVC Ethernet Policy

Setting the Service Options

Setting the Service Options

This section describes how to set the service options for the FlexUNI/EVC Ethernet policy, as shown in

Figure 3-2

.

Figure 3-2

EVC Policy Editor - Service Options Window

The Editable check box gives you the option of making a field editable. If you check the Editable check
box, the service operator who is using this FlexUNI/EVC policy can modify the editable parameter
during FlexUNI/EVC service request creation.

To set the FlexUNI/EVC service options, perform the following steps.

Step 1

Check the CE Directly Connected to FlexUNI check box if the CEs are directly connected to the N-PE.

This check box is not checked by default.

Usage notes:

If the check box is checked, a service request created using this policy can have only directly
connected links. No Ethernet access nodes will be involved.

If the check box is unchecked, a service request created using this policy might or might not have
Ethernet access nodes in the links.

When a CE is directly connected to the N-PE, NPCs are not applicable to the link while creating
service requests.

When a CE is not directly connected to the N-PE, NPCs are used during service request creation, as
per standard ISC behavior. There is no change in NPC implementation to support FlexUNI/EVC
functionality.

Step 2

Check the All Links Terminate on FlexUNI check box if all links need to be configured with
FlexUNI/EVC features.

This check box is not check by default. Usage notes:

If the check box is checked, a service request created using such policy will have all links using the
FlexUNI/EVC feature.

Advertising