Configuration (1) tab – Cisco 12000/10700 V3.1.1 User Manual

Page 187

Advertising
background image

7-7

Cisco 12000/10700 v3.1.1 Router Manager User Guide

OL-4455-01

Chapter 7 Interface Profiles

Creating an ATM Interface Profile

ATM Interface Configuration Profile Window—Detailed Description

The ATM Interface Configuration Profile window displays two tabs: Configuration (1) and
Configuration (2).

Configuration (1) Tab

The Configuration (1) tab (see

Figure 7-2

) displays two areas: ATM Configuration, and ILMI

Configuration.

ATM Configuration

The ATM Configuration area displays the following attributes:

Interface Type—Not applicable for Cisco 12000/10720 Router Manager.

ATM Interface Side—Not applicable for Cisco 12000/10720 Router Manager.

SVC UPC Intent—Not applicable for Cisco 12000/10720 Router Manager.

Neighbor Address Type—IP address of the neighbor system connected to the far end of this interface.
Not applicable for Cisco 12000/10720 Router Manager.

Neighbor Interface Name—Name of the connected interface on the neighbor system at the far end of this
interface. Not applicable for Cisco 12000/10720 Router Manager.

Loopback—Allows you to choose the loopback mode. The following options are available:

Line—Packets are transmitted back to the source to test the interface functionality and ensure that
packets transmitted through the interface reach the destination without data loss.

No Loopback—Restricts connection status (success or failure) messages from being received.

Diagnostic —Transmit data stream is looped to the transmit direction.

Maximum VPCs—Not applicable for Cisco 12000/10720 Router Manager.

Maximum VCCs—The maximum number of VCCs (PVCs and SVCs) supported at this interface.

Number of VCs per VP—Allows you to set the number of virtual channels per virtual path.

UNI Type—Not applicable for Cisco 12000/10720 Router Manager.

UNI Signalling Version—Version of UNI signalling that is currently being used on the interface. The
appropriate value, either atmfUni3Dot0, atmfUni3Dot1, or atmfUni4Dot0, is used when the interface is
an UNI or IISP interface. The value “not applicable” is used when the interface is a PNNI interface or
when signalling is disabled. Setting this variable to a value of not applicable is not allowed. To modify
this field, the interface admin status has to be down and the interface Ilmi auto configuration disabled.

Signalling Admin Status—Enables or disables signalling/sscop on this interface. The disabled action
causes all the active SVCs on this interface to be cleared. Not applicable for Cisco 12000/10720 Router
Manager.

Well-known VC Mode—Not applicable for Cisco 12000/10720 Router Manager.

Transmit Queue Limit—Not applicable for Cisco 12000/10720 Router Manager.

Maximum Active VPI Bits—Not applicable for Cisco 12000/10720 Router Manager.

Advertising