Cisco 12000/10700 V3.1.1 - Manual (Page 418)

14-28
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 14 Routing
BGP Address Family Configuration
AF-General Tab—Detailed Description
The AF-General tab displays two areas: BGP General and BGP Address Family Information.
BGP General
Local Autonomous System—The id of the BGP process running in the device. If the value is 0 it means
no BGP process is running on the device.
BGP Address Family Information
Address Family—Unique identifier of the address family type.
VRF Name—Identifier of the VRF Name if the address family type is ipv4 vrf.
Auto Summary—Displays whether the automatic network number summarization is enabled/disabled
for the address family.
Synchronization—Displays whether the BGP synchronization with IGP is enabled/disabled for the
address family.
Note This field is applicable only for the ipv4 unicast and ipv4 vrf address families.
Default Metric—Displays the default metric value set for redistributed routes of the address family.
Action
Modify Address Family—Clicking on the “Modify Address Family” button, opens the BGP Address
Family - Modify Address Family Parameters window.
Add/Remove Address Family—Clicking on the “Add/Remove Address Family” button, opens the
Configure Address Family window.
Configuring Address Family
The Configure Address Family window allows the user to create or remove BGP address families. To
add or remove a BGP address family, proceed as follows:
Step 1 Open the BGP Address-Family Configuration window. See “Viewing the AF-General Tab on the BGP
Address-Family Configuration Window” section on page 14-27 for further details. Click on the
AF-General Tab.
Step 2 Choose the chassis from the left side of the window.
Note You can choose multiple chassis (from the chassis list) which allows you to launch the Configure
Address Family window for the selected chassis.
Step 3 Click on the Add/Remove Address Family button to open the Configure Address Family window.