Cisco 12000/10700 V3.1.1 - Manual (Page 422)

14-32
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 14 Routing
BGP Address Family Configuration
Default Metric—This is used to set the value for the redistributed routes for the address family.
Note This attribute is not configurable only for the vpnv4 unicast address families. If this attribute is set to
zero, then the default metric is removed from the device for that address family.
Synchronization—This is used to enable/disable the BGP synchronization with IGP for the address
family.
Note This field is applicable only for the ipv4 unicast and ipv4 vrf address families.
Viewing the AF-Network Tab on the BGP Address-Family Configuration
Window
The AF-Network tab displays the network paths and the associated path information for the BGP address
family. The user can add or remove network paths for an address family. To view the AF-Network tab
on the BGP Address-Family Configuration window for a chassis, proceed as follows:
Step 1 Open the BGP Address-Family Configuration window. See “Viewing the AF-General Tab on the BGP
Address-Family Configuration Window” section on page 14-27 for further details.
Step 2 Click on the AF-Network tab.
Figure 14-21 BGP Address-Family Configuration Window—AF-Network Tab