Cisco 12000/10700 V3.1.1 - Manual (Page 428)

14-38
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 14 Routing
BGP Address Family Configuration
Send Community—This is used to select the community attribute sent in the route updates to a peer. The
default is not to send community attribute in route updates. The available options are: both, extended and
standard.
Update Source—To enable or disable BGP sessions to use a specific operational interface for TCP
connections. The available options are: No and Yes.
Note The Update Source command in the device can specify any interface (physical, virtual, loopback) to be
used as source IP address of the BGP session with the neighbor; but in the EM only the loopback
interface can be specified. This attribute is configurable only for the ipv4 unicast and ipv4 vrf address
families.
Loopback No—This is used to configure Router's Loopback Interface Number. This is valid only if
Update-Source is set to YES.
Note This attribute is configurable only for the ipv4 unicast and ipv4 vrf address families.
Action
Add Neighbor Entry—Clicking on the “Add Neighbor Entry” button, adds the neighbor entry for the
BGP Address Family.
Remove Neighbor Entry—Clicking on the “Remove Neighbor Entry” button, removes the neighbor
entry for the BGP Address Family.
Viewing the AF-Redistribute Tab on the BGP Address-Family Configuration
Window
The AF-Redistribute tab displays the information about the redistribute protocols configured for a BGP
address family. The user can add or remove the redistribute entries for an address family. To view the
AF-Redistribute tab on the BGP Address Family Configuration window for a chassis, proceed as
follows:
Step 1 Open the BGP Address-Family Configuration window. See “Viewing the AF-General Tab on the BGP
Address-Family Configuration Window” section on page 14-27 for further details.
Step 2 Click on the AF-Redistribute tab.