General tab, Power supply tab, Chassis fault management window—detailed – Cisco 12000/10700 V3.1.1 User Manual
Page 139
4-25
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 4 Managing Chassis
Chassis Fault Management
Chassis Fault Management Window—Detailed Description
The Chassis Fault Management window displays four tabs: General, Power Supply, Temperature, and
Fan.
General Tab
The General tab (see
) displays three areas: Chassis Availability, LED Status,
and Cisco Contact Details.
Chassis Availability
The Chassis Availability area contains attributes that reflect the availability of the chassis, as follows:
Up Time—Displays the up time after the last reset.
Last Changed Time—Displays the time the chassis hardware was last modified.
Note
Software and configuration changes through IOS CLI & SNMP are detected by SYSLOG and
ConfigManEvent traps (see
Chapter 18, “Fault Management,”
for further information) and the Event
Command History Table that can be launched from the Chassis.
Last Restart Reason—Displays the reason for the last restart.
Last Authentication Failure Address—Displays the last authorization failure IP address for the selected
chassis. The Last Authentication Failure Address field refers to the fact that the SNMP agent on the
Cisco 12000/10720 Router has received a protocol message that is not properly authenticated. The IP
address is the source of the message. This is a security issue which should be investigated.
Clock Source Status—Not applicable to Cisco 12000/10720 Router Manager.
LED Status
The LED Status area is not applicable to Cisco 12000/10720 Router Manager.
Cisco Contact Details
The Cisco Contact Details area displays any provided Cisco contact details.
Power Supply Tab
The Power Supply tab (see
) displays two areas: Power Supply and Voltage.
Power Supply
The Power Supply area displays the following information for each power supply (in tabular format):
Description—Textual information for the power supply.
State—Current state of the power supply. Possible state values can be Normal, Warning, Critical,
Shutdown or Not Present.
Source—Power supply source. Possible source values are: unknown, ac, dc, external, or internal
redundant.