Cisco 12000/10700 V3.1.1 - Manual (Page 200)

7-20
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 7 Interface Profiles
Creating a SRP Side Profile
Figure 7-14 Deletion Prompt Window
Step 3 Click Yes to delete the selected profile or click No to close the window without deleting the profile.
Figure 7-15 Information window
When a profile is deleted it disappears from the list of existing profiles displayed in the SRP Side Profile
list at the left of the window.
SRP Side Profile Window—Detailed Description
The SRP Side Profile window has two tabs namely: General, and Alarms
General Tab
The General tab displays four areas: General, SONET Overhead, IPS SONET and Create Profile.
General
The General area allows you to configure the following information:
Clock Source—Allows you to choose clock source from available options. This can either be internal
(within the device) or line (the network clock).
Loopback—Allows you to select the loopback mode. It indicates the loopback mode for the SRP Side
profile. The available options are: disabled, internal or line
Framing—Allows you to select sdh or sonet type framing. It indicates the framing mode of the side
profile.
IPS Management Request Mode—Allows you to select the IPS management request mode for the side
profile. The available options are: noRequest, forced-switch, manual-switch, waitToRestore,
signalDegrade, and signalFail.