Cisco 12000/10700 V3.1.1 - Manual (Page 57)

3-3
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 3 Getting Started
Starting Cisco EMF and Cisco 12000/10720 Router Manager
Starting Cisco EMF and Cisco 12000/10720 Router Manager
The Cisco 12000/10720 Router Manager application is viewed through the Cisco Element Management
Framework (Cisco EMF). It is important to understand how Cisco EMF works before you use the Cisco
12000/10720 Router Manager application (refer to the Cisco Element Management Framework User
Guide for further details). Cisco 12000/10720 Router Manager automatically starts when you start a
Cisco EMF user session.
Note Each active Cisco EMF session uses a single Cisco EMF user license.
This section covers the following:
• Starting a Cisco EMF User Session
• Launchpad
• Quitting a Cisco EMF User Session
Starting a Cisco EMF User Session
Note Cisco EMF should already be running. When you try to invoke a Cisco EMF session, and
if you receive a message that Cisco EMF is not running, contact your system administrator,
or refer to the Cisco Element Management Framework User Guide for further details.
To start a Cisco EMF user session, proceed as follows:
Step 1 From the command line on the terminal window, enter <CEMF_ROOT> /bin/cemf session
Note <CEMF_ROOT> is the Cisco EMF installation root directory (for example,
/opt/CEMF).