I selecting the drive mode – Canon EOS Rebel XT User Manual

Page 78

Advertising
background image

78

Single and continuous drive modes are provided. In the Basic Zone
modes, the optimum drive mode is set automatically.

Press the <

iQ> button.

¡

Look at the LCD panel and press the
<

iQ> button to select the drive

mode.

u : Single shooting

When you press the shutter
button completely, one shot will
be taken.

i : Continuous shooting

(Max. 3 shots per sec.)
While you press the shutter
button completely, shots will be
taken continuously.

Q : Self-timer/Remote control

(p.48/49)

i Selecting the Drive Mode

¡

During continuous shooting, the captured
images are first stored in the camera’s
buffer memory and then successively
transferred to the CF card. When the
buffer memory becomes full during continuous shooting, “buSY” will be
displayed on the LCD panel and in the viewfinder and the camera cannot
take any more shots. As the captured images are transferred to the CF
card, you will be able to capture more images. Press the shutter button
halfway to check in the viewfinder’s bottom right the current remaining
shots of the maximum burst.

¡

If “FuLL CF” is displayed in the viewfinder and on the LCD panel, wait
until the access lamp stops blinking, then replace the CF card.

¡

When the battery level is low, the maximum burst will be slightly lower.

Max. Burst

Advertising
This manual is related to the following products: