Hangar 9 Piper J-3 Cub 40 ARF - Manual (Page 25)

25
  Step 10
Cut the cable into four equal pieces. Prepare one cable by
sliding the cable through a crimp, through the cable end,
then back through the crimp twice. Pull the excess cable
tight and use a crimping tool to complete the job. Repeat
for all four of the ends.
 Step 11
Attach the four connectors to the brass fittings
of the stabilizer.
 Step 12
Repeat Step 10, only passing the cable through the brass
fittings instead of the cable ends. The cables should have
very light tension.
Section 7: Installing the Stabilizer