Chang Yue Industrial KN-8828P - Manual (Page 27)

1
2
3
4
1
2
3
27
COPYING AN EXISTING PROGRAM - KN-8828P
If you would like to create a new Program it can be easier and a bit quicker to begin with one that is
already created. Here is how to copy a Program and paste it into another Program slot:
DELETING A PROGRAM - KN-8828P
There are times when you may wish to remove a saved Program completely- possibly to make room
for duplicating a Program from areas 1 through 9. The following process will delete any Program in areas
1 through 9 (Program 0 cannot be deleted). To delete a Program:
Select the Program you wish to duplicate (see Page 24 for instructions on “Selecting a Program”)
Press SET/SAVE
Press SET/SAVE again. The LCD screen is now illuminated in green and the Program
has been copied to memory, and is now ready to be Saved (pasted) .
Select the Program you wish to delete
(see Page 24 for instructions on “Selecting a Program”)
Press “ ENTER” and the Program is permanently deleted.
CAUTION : Deleted programs cannot be retrieved, so use this function carefully!
CAUTION : When the STD Program is pasted it is written to the fi rst empty Program area. If all Pro-
grams are already used it defaults to Prog 1. This procedure may overwrite an existing Program without
warning if the user does not use care. Be sure that there is an empty Program before proceeding!
It is always a good idea to record all successful programs so that they can be re-entered later if lost.
Duplicate and use the handy charts we have included on page 42 and 43 for that purpose.
When the Program you wish to delete is displayed in the “Prog” area
and it’s name is showing in the Message Center, press and hold both “ <”
AND “ >” for about two seconds. When this has been successfully done the
screen will turn red.
A
N
D
CAUTION : When a Program is deleted, its area in memory will be empty and ready for entering a
new Program, but the deleted program cannot be retrieved.
It is a good idea to record all successful programs so that they can be re-entered later if lost. Duplicate
and use the handy charts we have included on page 42 and 43 for that purpose.
5 Press ENTER and the Program is pasted.
If necessary, use the + and - keys to navigate to the desired Program area. Programs
1-9 can only be copied when there are empty Program areas. After copying, only empty
Program areas will be accessible using + and - for pasting Programs 1-9.
Copying Program 0 will automatically select the fi rst empty Program area. If there
are no empty Program areas, Program “1” will be automatically selected after Program
0 has been copied. This happens even if Program 1 is not empty, so copy Program 0
with care. Be sure to check the current Program number before pasting.