Chang Yue Industrial KN-8828P - Manual (Page 31)

31
PROGRAM NAME
This next adjust allows you to change the Program’s name (indicated as *3 in the fl ow chart on page
29). This can be a three-character, alpha-numeric name you choose from these available characters:
Capital letters from A to Z Numerals from 0 to 9 “_” to signify a blank
To aid in understanding the Naming Procedure, refer to this fl ow chart:
The fi rst character in the Program’s Name is now blinking. Use the “+”
and “-” to scroll forwards and backwards through the available list of char-
acters. The list wraps and can be scanned faster by holding the button down.
When the desired character is displayed press “<” or “>” to move to the next
position in the Program’s Name. Repeat this process, and when all three
characters meet with your approval press “ENTER” to move on. Be aware
that this changes the name for the entire Program and not just one Segment.
TIME
Segment Time is the next step in the adjustment process. This can be from “0:00” to “3:00.” No seg-
ment can be more than three minutes, and the total of all the segments cannot be more than 22:00. When
the amount of time for this segment is as you desire, press “ENTER” and you will return back to the top
of the process at Temperature.
At this point you need to select the next Segment for modifi cation. Press “>” or “<” to move to the
next adjacent segment (*1). The Segment that is selected will display all its temperature bars and you can
go through all the settings as described above. Repeat this process for all Segments. You may change the
current Segment at any time during this Program modifying process.
ABANDON CHANGES
You may select “BACK/EJECT” at any time during this procedure you leave the Program modifi ca-
tion process and your changes are discarded (*2). You are brought back to the Program Selection screen.
SAVE CHANGES
When your changes are completed and you wish to save this Program and all the changes you have
made to it, Press “SET/SAVE” and the LCD screen will turn green and the Message Center displays
“SAVE.” Now press “ENTER” and the changes will be saved.
You can begin roasting with this profi le by pressing “Enter” once again, and then “POWER/
START.”
CHANGING ONE PARAMETER - “Quick Programming”
An alternative to the process described above makes use of the fl exible programming methods of the
KN-8828P. Instead of modifying all the parameters for each Segment, one Segment at a time, you may
wish to modify only one of the parameters for all Segments. For example, if you only want to change the
Temperature settings for all the Segments and wish to leave the other parameters alone, follow these direc-
tions:
Just as with the previous method, enter the “Program” mode and select the Program to be modifi ed.
Press “SET/SAVE.” The “SET/SAVE” button turns green signifying that you are in the setting mode to
change parameters for the selected Program. You have entered the area of the Program Modifi cation fl ow
chart (page 30) that is indicated inside the blue rectangle.
The setting mode defaults to Segment 1 and “Temperature.” You will notice that the all the bars of
Segment 1 are displayed and a temperature bar signifying the current selected temperature for Segment
1 is blinking and the digital temperature display is blinking. Using the “+” and “-” buttons you can now
adjust the temperature for Segment 1 as desired. When you have adjusted the Temperature to the desired
level, move to Segment 2 by pressing “>”. You will notice that the temperature bars of Segment 2 are
displayed. Adjust the temperature for Segment 2 and once again press “>” this time to move to Segment 3.
Continue this process until all the temperature settings are to your liking. You can now either save the Pro-
gram or use “Enter” to move to the next parameter (Fan) and adjust the Fan speed for all the Segments.