Hardy HI 3030 Multi-scale Weight Controller - Manual

QUICK INSTALLATION GUIDE
Mechanical Installation
Installing the HI 3030 Weight Controller in a Panel
FIG. 1 PANEL CUTOUT DIMENSIONS
Step 1. Make sure that all Electrostatic Discharge (ESD) precautions
are taken before and during installation.
Step 2. Slide the gasket over the rear of the instrument until the gasket
is flush with the back side of the front panel. (See Fig.2)
FIG. 2 PANEL MOUNT INSTALLATION
Step 3. Gently slide the Weight Controller with the gasket into the cut-
out in the enclosure front panel or door until the gasket is flush
with the enclosure front panel. (See Fig. 3-4) Be sure to secure
the instrument with both hands when installing.
Step 4. Gently slide the Panel Mount Collar over the rear of the instru-
ment. (See Fig. 2)
Step 5. Push the captive screws through the holes in the Enclosure
Front Panel and install the screws into the tapped holes on the
instrument until the screws are finger tight.
Step 6. Use a slotted head screwdriver and tighten each screw until the
instrument is snug against the panel. Use a torque screw driver
and torque each screw to 10 inch/pounds. DO NOT OVER-
TIGHTEN!
Installing the HI 3030 Weight Controller in a Swivel/Wall
Mount
NOTE: When mounted on a wall the unit should support a
weight of 14 lbs for one minute without coming loose
or damaging the equipment or fasteners.
Step 1. Use four (4) 1/4 x 20 fasteners to fasten the swivel mount to a
horizontal surface. (See Fig. 3)
FIG. 3 INSTALLING THE SWIVEL MOUNT TO A HORIZON-
TAL SURFACE
Step 2. Place the Weight Controller between the Swivel Mount brack-
ets so that the threaded holes in the instrument are aligned with
the slots in the Swivel bracket. (See Fig.4)
FIG. 4 WEIGHT CONTROLLER INSTALLING IN A SWIVEL
MOUNT
Step 3. Screw the two fastener knobs into the threaded holes on each
side of the Weight Controller until the brackets are snug
against the instrument. (See Fig. 5)