Hardy HI LPRE05 Shear Beams User Manual
Hardy Scales
Advertising
HI HLPS SERIES
LOAD POINT ASSEMBLIES
OPERATION AND INSTALLATION
MANUAL
Corporate Headquarters
9440 Carroll Park Drive, Suite 150
San Diego, CA 92121
Phone: (858) 278-2900
FAX: (858) 278-6700
Web-Site: http://www.hardysolutions.com
Hardy Process Solutions Document Number: 0596-0237-01 Rev G
Copyright 1999-2013 Hardy Process Solutions All Rights Reserved. Printed in the U.S.A. (941028)
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- HI HLPS SERIES
- LOAD POINT ASSEMBLIES
- OPERATION AND INSTALLATION
- MANUAL
- Local Field Service
- Outside the U.S
- General Information
- Three Load Point Types
- Unpacking
- Installation of the Ground Strap
- Site Preparation
- Precautions
- Basic Engineering Principles for Positioning Load Point Assemblies
- Typical Mounting Arrangements
- Round Vessel with 3 Load Point Assemblies
- Round Vessel with 3 Load Point Assemblies - Angle Config. #1
- Round Vessel with 3 Load Point Assemblies - Angle Config. #2
- Square Hopper with 3 Load Point Assemblies - Even Load Distribution
- Square Hopper with 3 Load Point Assemblies - Uneven Load Distribution
- Round Vessel with 4 Load Point Assemblies
- Typical 4 - Load Point Assembly Installation
- Typical 6 - Load Point Assembly Installation
- Level Requirements
- Stiffness
- Installation Procedures
- Adjusting the Anti-Lift Off Device
- Replacing the Load Sensor
- Troubleshooting
- Electrical Termination Cable Color Codes
- Model Numbers
- Specifications