Hardy HI LPRE05 Shear Beams - Manual (Page 9)

OPERATION AND INSTALLATION MANUAL
Page 3
Unpacking • Do not remove the load point assembly from it’s
packaging until just before installation. Although
the load sensor is designed for harsh environ-
ments, it is a precision instrument and should be
treated as such.
• Inspect the box, packing and the load point
assembly for any signs of damage that might
occur during shipment. Since almost all of the
load point assemblies are shipped F.O.B. our fac-
tory, such damage is normally the responsibility
of the carrier and should be reported to them.
• LOAD SENSOR CERTIFICATION SHEETS
ARE AVAILABLE 24 HOURS A DAY IN
THE SUPPORT SECTION OF OUR WEB-
SITE: http://www.hardysolutions.com
• Write down the serial number(s) on the inside of
the back cover for reference when talking to
Hardy Customer Service. Store this information
in a secure dry location for future reference.
Installation of the
Ground Strap Step 1. Cut the plastic strap that fastens the
ground strap to the Load Point Assembly.
Step 2. Use a box-end wrench to remove the two
shipping brackets from the load point. (See
Fig. 4)
FIG. 4: REMOVING SHIPPING BRACKETS
Step 3. Remove the shipping brackets, which are
intended only for use during shipment
from the factory. They offer no protection