Inovonics FA209 - Manual

FA209
Frequency Agile
! ! ! !
900MHz
BilltrapTransmitter
Installation Instructions
02109C
FA209 Billtrap Operation
The FA209 billtrap transmitter is designed to be used in retail and banking cash drawers.
When the trigger bill is removed, the billtrap will send an alarm transmission. The user can
opt for instant or delayed transmission of the alarm.
Hook and loop mounting square
Billtrap
Important Notes
!" These products are designed to be installed and maintained
by professional security technicians.
!" Products, unless specifically noted, are intended for indoor use.
!" Manually test all products regularly.
© 1995 Inovonics Wireless Corporation
315 CTC Blvd, Louisville CO 80027
(800) 782-2709
FAX (303)939-8977
E-mail: [email protected]
www.inovonics.com
02109C.DOC LIT-FA209-INSTALL hc:8-Aug-01
FA209 Installation
1. Remove bottom plate.
2. Set DELAY SELECTOR jumper.
3. Program transmitter.
4. When programming is complete, disconnect cable and re-attach bottom plate.
5. Mount the billtrap in the cash drawer using hook and loop square provided, or other means.
6. Place trigger bill in the billtrap.
FA209
Billtrap Transmitter
3V
3V RESET BUTTON
TAMPER BUTTON
PROGRAMMING
HEADER
DELAY SELECTOR
FA209 Specifications
Program
contacts: N/O
EOL: No
Internal Contacts: No
Typical battery life: 1-2 yrs @ 60-second* check-in
Battery (BAT609): 3.0V lithium CR2450N, quantity 2
(Batteries always supervised)
Dimensions: 6.188" x 2.625" x .750"
* NOTE: The FA209 doubles the programmed check-in interval, resulting in extended battery life. A unit programmed
for 60-second check-in will actually send a check-in round every 120 seconds.
Delay Selector Settings
Placement of the selector jumper determines whether or not the transmitter will delay before
sending an alarm. The delay lets users quickly replace the trigger bill if it has inadvertently
been removed from the billtrap. With the jumper in the delay position, the alarm will be
delayed for 7 to 13 seconds. NOTE: Instant response time will be 0 to 2.4 seconds.
10 SECOND DELAY
INSTANT ALARM
FA209 Programming
1. When prompted to plug in transmitter, connect cable from programming device to
programming header on transmitter.
2. Press reset button on transmitter.
3. When programming is complete, disconnect cable.
NOTE: The FA209 retains programming data in non-volatile memory. It does not
require re-programming after loss of power. Install new batteries and press reset
button to re-initialize the transmitter and restore programming.
ATTENTION: Test the transmitter at least once each week. See warranty.