Avlink SK-101 - Manual

RGB SKEW
CAL.
(SK-101)
U SER M ANUAL
Package Contents-
ƒ SK-101 Unit
ƒ 1 user manual
ƒ 1 power adapter DC 12V/600mA
ƒ 1 VGA 1.2M cable (HD-15 Male to Male)
Any thing missed, please contact with your vendor.
Introduction
SK-101 provides perfect skew delay correction. This delay
is as a divaricately result of transmitting RGB signals over
CAT5 cables. The skew level in CAT5 cables is negligible
when distances below 150M. However skew become
significant when using CAT5 over longer distances.
We suggest, when distances over 150M it is needed.
Features
ƒ 62ns total delay
ƒ 2ns delay step increments
ƒ Memorize function
ƒ Button locked function
Specifications
Function SK-101
VGA IN Connector 1
VGA OUT Connector 1
Max. Resolution 2048x1536 60Hz
Power Adapter (Min.) DC 12V 600mA
Housing Aluminum
Weight 225 g
Dimensions (LxWxH) mm 130x85x29.5
FRONT VIEW
1. R channel up button
2. R channel down button
3. G channel up button
4. G channel down button
5. B channel up button
6. B channel down button
7. Lock button
8. Power LED
9. Locked LED
-1-
REAR VIEW
1. VGA Output
2. VGA Input
3. Power jack
Installation
1. Connect VGA IN port HD-15 female connector with
HD-15 male to male cable from device RGB signals.
2. Connect the VGA OUT port HD-15 female connector
with HD-15 male to male cable from monitor.
3. Connect the power adapter.
4. Adjust RGB up and down button.
5. Push lock button to set data as original setting, so that
when the machine reboot it can keeps in this setting.
Operation
A. Lock/Unlock channel key
ƒ The key controled lock (Locked LED on) or unlock
(Locked LED off) all skew adjusted keys.
ƒ Press this key to toggle switch lock/unlock.
ƒ The skew delay value will been written to EEPROM
when switch from “Unlock” to “Lock”.
ƒ Recommand you keep in lock mode when you
complete skew setting.
B. Adjust/Reset R,G,B skew value
ƒ You have to make sure that calibrator was in unlock
mode. (Locked LED off)
ƒ Press “Up”/”Down” key once for increase/decrease
2ns delay on each color.
ƒ Press “Up” and ”Down” key on the same time for set
0ns delay on this color.
ƒ Press “Up” or ”Down” key and hold 1 second, repeat
increase/decrease function continually.
© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.
-2-