Cisco ATM and Layer 3 Switch Router OL-1911-05 - Manual (Page 21)

24-21
ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05
Chapter 24 Configuring ATM Router Module Interfaces
Configuring Classical IP over ATM in an SVC Environment
NSAP Address Example
Figure 24-7 shows three ATM switch routers and a router connected using classical IP over ATM.
Figure 24-7 Classical IP over ATM Connection Setup
The following example shows how to configure the ATM router module interface ATM 1/0/0 of Client A
in
Figure 24-7 , using the NSAP address:
Client A(config)# interface atm 1/0/0
Client A(config-if)# atm nsap-address 47.0091.8100.0000.1111.1111.1111.1111.1111.1111.00
Client A(config-if)# ip address 123.233.45.1 255.255.255.0
Client A(config-if)# atm arp-server nsap 47.0091.8100.0000.1111.1111.1111.2222.2222.2222.00
Client A(config-if)# exit
Client A(config)# atm route 47.0091.8100.0000.1111.1111.1111.1111.1111.1111 atm 1/0/0 internal
ESI Example
The following example shows how to configure the ATM router module interface ATM 1/0/0 of Client A
in
Figure 24-7 , using the ESI:
Client A(config)# interface atm 1/0/0
Client A(config-if)# atm esi-address 0041.0b0a.1081.40
Client A(config-if)# ip address 123.233.45.1 255.255.255.0
Client A(config-if)# atm arp-server nsap 47.0091.8100.0000.1111.1111.1111.2222.2222.2222.00
Client A(config-if)# exit
Router client C
123.233.45.6
Switch client A
123.233.45.1
Switch client B
123.233.45.3
Switch ARP server
123.233.45.2
ATM network
123.233.45.0
27082