Component testing, Water inlet valve – Whirlpool Thin Twin User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
13. CLOTHING
DAMAGE
Excessive use of bleach
Instruct customer
Overloading of machine
Instruct customer
Foreign objects
Remove
Water level too low
Increase water level
Agitates during spin
See problem 8
Agitator surface rough
Replace agitator
Basket surface rough
Replace basket
14. GEARCASE
LEAKS OIL
Leak at aaitator shaft
Replace seal
Leak at cover seal
Reseal
Too much oil in gearcase
Use only 13-15 ounces in gearcase
Defective cover
Replace cover
15. WATER LEAKS
Use of iow water level with high
agitation
Advise customer to use higher water
level
Leaking components
Repair or replace
16. BRAKE SQUEAL
Contaminated linings
Replace brake shoe assembly
COMPONENT TESTING
NOTE:
Refer to the wiring diagram for the specific mode! being serviced. The wiring
diagram can be found behind the transition panei.
WATER INLET VALVE
To test the water inlet valve, remove the wiring harness connectors from each solenoid.
Set the meter on the R X 100 scale and attach the meter probes to the terminals on each solenoid.
The meter should show between 200 and 900 ohms resistance.
18