Cisco OL-5742-01 - Manual (Page 2)

Chapter 18 Configuring SGM Security
Configuring SGM User-Based Access
18-2
Cisco Signaling Gateway Manager User Guide
OL-5742-01
• Manually Disabling Users and Passwords (Solaris Only), page 18-14
(Optional)
• Enabling and Changing Users and Passwords (Solaris Only), page 18-16
(Optional)
• Displaying a Message of the Day, page 18-18 (Optional)
• Manually Synchronizing Local SGM Passwords, page 18-21 (Optional)
• Listing All Currently Defined Users, page 18-21 (Optional)
• Displaying the Contents of the System Security Log, page 18-22 (Optional)
• Restoring Security-Related SGM Data, page 18-23 (Optional)
• Disabling SGM User-Bases Access, page 18-24 (Optional)
• Specifying a Super User (Solaris Only), page 18-24 (Optional)
Implementing SGM User-Based Access (Solaris Only)
Before you can access SGM’s full suite of security commands, you must enable
SGM User-Based Access, configure the type of security authentication you want
to use, and begin adding users to your authentication lists.
To implement SGM User-Based Access, use the following procedure:
Step 1 Log in as the root user, as described in the “Becoming the Root User (Solaris
Only)” section on page 2-3 , or as a super user, as described in the “Specifying a
Super User (Solaris Only)” section on page 18-24 .
Step 2 Enter the following commands:
# cd /opt/CSCOsgm/bin
# ./sgm useraccess enable
SGM User-Based Access is enabled the next time you restart the SGM server.