Conair BE18LCX - Manual

IMPORTANT SAFETY
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
THE APPLIANCE.
DANGER–
TO REDUCE THE RISK OF
ELECTRIC SHOCK: ALWAYS UNPLUG THE MIRROR
FROM THE ELECTRICAL OUTLET WHEN NOT IN USE
AND BEFORE CLEANING.
WARNING–
TO REDUCE THE RISK
OF BURNS, ELECTROCUTION, FIRE, OR INJURY
TO PERSONS:
1. Unplug from outlet before putting on or taking
off parts.
2. This mirror should not be used by or near children
or by individuals with certain disabilities.
3. Use mirror only for intended use as described in
these instructions. Do not use attachments not
recommended by the manufacturer.
4. Never operate this mirror with a damaged cord
or plug, if it is not working properly, if it has been
dropped or damaged or dropped into water.
Return mirror to a service center for examination,
and repair.
5. Keep cord away from heated surfaces.
6. Never drop or insert an object into any opening.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products
are being used, or where oxygen is being
administered.
9. To disconnect, turn all controls to the off position,
then remove plug from outlet.
10. Unplug the appliance from outlet before
cleaning. Do not leave appliance unattended
when it is plugged in
11. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause
a fire.
12. Do not use on a soft surface such as a bed,
where openings may be blocked.
13. Turn switch to Off position and unplug cord
before replacing light bulbs.
14. Do not place or store mirror where it can fall or
be pulled into a tub or sink.
15. If mirror falls into water, unplug it immediately.
Do not reach into the water.
16. To protect against electrical hazards, do not use
while bathing or in the shower.
17. Never use while sleeping.
18. Do not use bulb greater than 20 watts.
19. Use in any 120 volt, 60 hertz AC electric outlet
(ordinary house current). Do not use it in any
other electrical outlet.
FOR HOUSEHOLD USE ONLY
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a
polarized plug (one blade is wider than the other). This
plug will fit into a polarized outlet only one way. If the
plug does not fit fully into the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in
any way.
1. Your vanity lighted makeup mirror is 7.5"
diameter with 5x and 1x magnification.
2. The mirror head rotates 360º to any convenient
viewing angle.
3. Plug cord into any standard 120 volt wall outlet.
To turn on lights, simply turn the dial on the base
to desired light setting.
4. After use, always turn switch to the Off position.
5. The beauty and design of the Classique
™
Collection mirror complement any decor. Therefore,
you may wish to leave the mirror displayed.
However, if you choose to store the mirror, see
STORAGE for detailed information.
SPECIAL FEATURES
This lighted makeup mirror uses incandescent light
bulbs with special coating, reproducing shadow-free
lighting in four different settings: evening, home,
office and day.
TO REPLACE BULB
CAUTION: TURN OFF POWER AND UNPLUG. ALLOW
TO COOL AT LEAST 3 MINUTES BEFORE REPLACING
BULB.
NOTE: Do not use a bulb greater than 20 watts.
Contact a Conair service center at 1-800-3 CONAIR for
replacement bulb information – ask for replacement
bulb pack RP3435B (1 clear, 1 blue). Bulbs are $9.99
(for the pack – 2 bulbs).
1. Remove screws from top and bottom of mirror
(Fig. 1).
2. Carefully lift off the removable housing from the
half that is affixed to the stand.
3. Unscrew the old bulb and replace with the
new bulb (Fig. 2).
4. Carefully replace the removable half after locating
and aligning the screw holes to the fixed half.
5. Insert screws into screw holes and tighten.
Figure 1
Figure 2