Threading the bobbin case – Kenmore 17922 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
THREADING THE BOBBIN CASE
(D
1. Remove accessory box.
2. Remove bobbin cover plate by lifting up
the front.
3. Insert bobbin into bobbin case making
sure bobbin rotates counter clockwise.
5.
Pull thread through slot (B) and leave
about 4 inches of thread.
6.
Replace bobbin cover plate allowing
thread to emerge through slot in needle
plate.
4. Pull thread through slot (A) and then to
the left.
Advertising
This manual is related to the following products: