Needle plates, Changing needle plate, Feed cover plate – Kenmore 17922 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

NEEDLE PLATES

You are provided with two needle plates:

A. Needle plate with wide oval hole for all

zigzag stitches and striaght stitch with

needle at "C" (center) or "R" (right)
position.

B. Needle plate with round hole for straight

stitch with needle at "S" (standard)
position.

CHANGING NEEDLE PLATE

1

.

2

.

3.

4.

6

.

Raise needle to its highest position and
raise presser foot.

Remove bobbin cover plate.

Remove needle plate by placing thumb
under edge of plate and lifting up and out.
(See Fig. 2)

Make sure bobbin case is in the proper

position by turning in the counter­
clockwise direction as indicated by red

arrow on the bobbin case stopper until it
stops. (Fig. 3)

Snap desired needle plate into place.
(Fig. 4)

Replace bobbin cover plate.

NOTE:

Don't turn hand wheel while needle plate is

removed, or needle may hit bobbin case and
cause needle damage.

Don't touch screws on the bobbin case

stopper.

If bobbin case is not installed as indicated

above, it will be damaged when the needle
plate is put into position.

FEED COVER PLATE

There are a few times when you want to
control the feeding of the fabric yourself.

Raise needle to its highest position and raise

presser foot. Place feed cover plate over
needle plate aligning two pins of feed cover
plate with holes of needle plate. You may
then determine the movement of the fabric
yourself.

Fig. 2

5

1

o

1

1

1

1

o t

PP

J ___ L

Fig.3

Bobbin case Bobbin case ^'9- 4

stopper

Advertising
This manual is related to the following products: