Kenmore POWER MISER 153.330551 - Manual (Page 11)

Installation Instructions (cont*d)
Water Piping
AWARNING
HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature vdiidt will
satisfy clothes wasMng, dish washing, and otl^ sanitizing needs
cat ¿aid and pennanentfy injure you upon contact Some peo*
pie are more likely to be pennanently injured by hot water than
others. These include the elderiy; children, the infirm, or physkai-
fy/n№ntally handicapped. If anyone using hot water in your home
fits into one of these groups or if there is a local code or state law
requiring a certain temperature water at the hot water tap, then
you must take specid precautions. In addition to using the lowest
possible temperature setting that satisfies your hot water needs,
a means such as a mbdng valve, should be used at the hot wrater
taps used by these people or at the water heater. Mixing valves
are available at plumbing supply or hardware stores. Follow man­
ufacturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
'Temperature Regulation” section in this manual.
This water heater shall not be connected to any heating systems or
component(s) used with a non-potable water heating appliance.
If a water heater is installed in a closed water supply system;
such as one having a back-flow preventer, check valve, water
meter with a check valve, etc... in the cold water supply; means
shall be provided to control thermal expansion. Contact the
local utility or local Sears Service Center on how to control this
situation.
NOTE: To protect against untimely corrosion of hot and
cold water fittings, it is strongly recommended that di-elec­
tric anions or couplings be installed on this water heater
when connected to copper pipe.
The illustration shows the attachment of the water piping to the
water heater. The water heater is equipped with
Vi'
water con­
nections.
NOTE: If using copper tubing, solder tubing to an adapter
before attaching the adapter to the cold water inlet connec­
tion. Do not solder the cold water supply line directly to the
cold water inlet. It will harm the dip tube and damage the
tank.
• Look at the top cover of the water heater. The warer outlet is
marked hot. Put two or three turns of teflon tape around the
threaded end of the threaded-to-sweat coupling and around
borh ends of rhe
%"
threaded nipple. Using flexible connec­
tors, connect the hot water pipe to the hot water outlet on
the water heater.
• Look at the top cover of the water heater. The cold water
inlet is markecT cold. Put two or three turns of teflon tape
around the threaded end of the threaded-to-sweat coupling
and around both ends of the
Y"
threaded nipple. Using flexi­
ble connectors, connect the cold water pipe to the cold water
inlet of the water heater.
NOTE; This water heater is super insulated to minimize
heat loss fi:om the tank. Further reduction in heat loss
can be accomplished by insulating the hot water lines
firom the water heater.
INSTALLATION COMPLETED USING
SEARS INSTALLATION KIT
HOT OUTLET FLEXIBLE WATER COLD INLET
11