Seff-cleaniag cycle (coat.), Seff-cleaniag cycle (coat.) to set a clean cycle, After the cycle – Kenmore 911.93508 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
cua MHD cuAmm
Seff-Cleaniag Cycle (coat.)
TO SET A CLEAN CYCLE
1. For best results, follow the steps
in PREPARING YOUR OVEN.
2. Slide the self-dean lock handle to
the right as far as it wilt go. Do not
force the handle.
4.
Turn the oven control knob to
CLEAN. The CLEAN and OVEN
ON indicator lights wiii glow.
If the CLEAN indicator flashes, the
door is not closed completely.
Simply push the handle to the lock
position.
The clean cycle lasts 4 hours
and 20 minutes—this includes a
cool-down time. You may change
this to any time from 3 hours to 5
hours and 59 minutes by touching
the HOUR/MIN UP and/or DOWN
arrow pads.
When the door locks, CLEAN
and OVEN ON indicator lights
will glow. The oven temperature
must drop below the locking
temperature before the door can
be opened. The CLEAN and
OVEN ON indicators will blink at
the end of the cycle.
5. Turn the OVEN CONTROL KNOB
to the OFF position and unlock the
door.
TO SETA DELA YED CYCLE
1.
2
.
Make sure the correct time of day
is displayed.
For best results, follow the steps
in PREPARING YOUR OVEN.
3. Slide the self-clean lock handle to
the right as far as it will go. Do not
force the handle.
4. Turn the OVEN CONTROL KNOB
to CLEAN. The CLEAN and OVEN
ON indicator lights will glow.
5. To delay the start of the clean
cycle touch the START TIME ON/
OFF pad,
6. Touch the HOUR/MIN UP and/or
DOWN arrow pads to set the time
of day you want the oven to start
cleaning.
7. When the cycle is finished, the
OVEN ON and CLEAN indicator
lights will flash. Turn the OVEN
CONTROL KNOB to the OFF
position and unlock the door.
TO STOP A CYCLE
Turn the OVEN CONTROL KNOB to
the OFF position. Wait (approx. 1
hour) before attempting to open the
door. The indicator light will not blink if
the cycle is stopped.
AFTER THE CYCLE
After the cycle, you may notice some
white ash in the oven. Just wipe it up
with a damp cloth or sponge.
If white spots remain, scrub them
with a soap-filled steel-wool pad. Be
sure to rinse thoroughly. These are
usually deposits of salt that cannot be
removed during the cycle.
If for any reason you are not
satisfied with the cleaning
results, Just repeat the cycle.
21
20Pie36E№Ol4>m«
2/24/00,9:35 AM