Locating the bracket, Impomaht safety, Anti-tip bracket – Kenmore 911.93508 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SAVE THESE INSTRUCTIONS
Read all Inatructiona before using №ls appliance. When using gas
or aiectricai appliances, basic safety precautions should be followed.
Including the following;
All Ranges Can Tip
:• Injury to Persons
These ANTT-TIP bracket installation
instructions are for wood or concrete
floors and walls. Any other type of
construction may require special
Installation techniques to provide
adequate fastening of the ANTI-TIP
bracket to the floor and wall.
The use of this bracket does not
prevent tipping of the range when
bracket is not properly installed.
NOTE: The installation of the
ANTI-TIP bracket must meet all
local codes for securing appliance.
Locating the bracket
Locate the bracket against the rear
wall and either the right or left
cabinet. If the countertop
overhangs the cabinet, offset the
bracket from the cabinet by the
amount of overhang. If there is no
adjacent cabinet, position the edge
of the bracket at the desired
location of the range side panel.
B. Use the bracket as a template
and mark 2 hole positions on the
wall and 2 hole positions on the
floor. Use either the wood or
concrete floor set of positions,
depending on your floor type.
See Fig. 1.
Adjacent Cabinet or
nnal LocatloR of Range
eondnued on next page
ZrZUQO, 9-J4 AM