Room air conditioner troubleshooting guide, The air conditioner will not operate – Kenmore 253.79184 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Room Air Conditioner Troubleshooting Guide

THE AIR CONDITIONER WILL NOT OPERATE

Check if-• •

Then-"

Power supply cord is disconnected

Firmly push the cord into a live wall outlet having proper voltage. (Page 4)

House fuse has blown or circuit breaker tripped

Replace the fuse with a time delay type or reset the circuit breaker. (Page 4)

Power is OFF.

Push ON/OFF Button to turn ON. (Page 6)

Temperature setting is warmer than room temperature.

Set temperature to a lower setting. (Page 6)

Unit was turned OFF and ON too quickly.

Built-in delay will prevent compressor from turning on for 3 minutes.

Timer shut unit OFF.

Push ON/OFF Button to turn unit ON. (Page 6)

Touch Pad and Remote not responding.

Unit is in a locked mode. Unplug unit for 10 seconds, and then plug in again and

the controls will reset. (Page 4)

Power Cord has tripped

Press the RESET button on the plug head. (Page 4)

THE AIR CONDITIONER BLOWS FUSES 0

R TRIPS CIRCUIT BREAKER

Check if"

Then---

House fuse has blown or circuit breaker tripped.

Replace the fuse with a time delay type or reset the circuit breaker. (Page 4)

Too many electrical devices are being used on the same circuit.Unplug or relocate electrical devices being shared on same circuit.

Unit is rated over 7.5 amps.

Unit should be plugged into a single circuit outlet.

Unit is plugged into an extension cord.

Do not use an extension cord to run the unit. (Page 4)

Unit was turned OFF and ON too quickly.

Turn unit OFF and wait 3 minutes before restarting. (Page 6)

THE AIR CONDITIONER TURNS ON AND 0

FF BY ITSELF

Check if-• •

Then---

Outside temperature is extremely hot.

Set fan speed at the fastest setting for maximum cooling. (Page 6)

ENERGY SAVER feature is on.

ENERGY SAVER feature does not circulate air continually. Set mode to COOL for

constant air circulation. (Page 5)

Timer turned unit ON or shut unit OFF.

Push ON/OFF Button to turn unit ON or OFF. (Page 6)

THE AIR CONDITIONER DOES NOT COOL THE ROOM - ICE BEHIND FRONT PANEL

Check if"

Then---

Outside temperature is below 60°F.

Set mode to FAN ONLY and fan speed to fastest setting to defrost coil. (Page 6)

Filter is dirty.

Open front panel. Remove filter. Rinse or vacuum filter. Replace filter. Close Panel
(Page 9)

BTU size is too large.

A lower capacity unit may be required depending on the size of the room being
cooled. (Page 9)

THE AIR CONDITIONER DOES NOT COOL THE ROOM - NO ICE BEHIND FRONT PANEL

Check if--

Then---

Filter is dirty.

Open front panel. Remove filter. Rinse or vacuum filter. Replace filter. Close Panel
(Page 9)

Temperature setting is warmer than room temperature.

Set temperature to a lower setting. (Page 6)

Room temperature is below 60°F.

Unit is not designed to cool below 60°F.

Front of unit is blocked by furniture, drapes, blinds, etc.

Clear away area in front of unit.

Back of unit is blocked by leaves, dirt, branches, etc.

Clear away back of unit.

Doors, windows, registers, etc. are open.

Close doors, windows, registers, etc.

Unit recently turned on.

Allow time to cool a larger room.

Temperature sensor is touching the coil.

Open front panel. Remove filter. Turn end of temperature sensor away from coil.
Replace filter. Close panel.

Excessive heat in the room being cooled.

Use exhaust vents while cooking or bathing. Limit use of heat producing appliances

during the hottest part of the day. (Page 9)

Vent control (on some models) is pulled open.

Push in vent control for maximum cooling. (Page 8) (CLOSED POSITION)

10

Advertising
This manual is related to the following products: