Kenmore 25351399106 - Manual (Page 16)

Automatic ¡ce and Water Dispens^^
^WS:SMÈÌImlm&
x..: xx x x x x x x x x x x x x x x x x x x x x x x x x x x x
Do not use the
ice chute as a
handie
when
removing or
repiacing the
ice storage bin.
Surfaces there
may be sharp.
Do not put fingers up ice chute. Surfaces
there may be sharp.
CLEANING THE ICE DISPENSER
Clean the dispenser and ice container at regular intervals,
particularly before you take a vacation or move, or if the ice
dispenser sticks.
1. Stop ice production by lifting the wire signal arm to the "up" or
OFF position.
2. Remove ice container by lifting up and out. Empty and
carefully clean the container with mild detergent. Rinse with
clear water. Do not use harsh or abrasive cleaners. Allow ice
container to dry completely before replacing in the freezer.
3. Remove ice chips and clean the shelf and chute that supports
the ice container.
4. Replace the ice container. Lower the wire signal arm on the ice
maker to the "down" or ON position and the ice maker will
resume production.
IMPORTANT; When removing or replaj
rotate the auger in the ice bin. If the auger
you must realign the auger by turning it iii
bin fits into place with the drive mechanism. cing the ice bin, do not
is accidentally turned,
90” turns until the ice
Remove and empty the ice storage bin if:
1. An extended power failure (one hour or longer) causes ice
cubes in the ice storage bin to melt and freeze together and
jam the dispenser mechanism.
2 The ice dispenser is not used frequently. Ice cubes will freeze
together in the bin and jam the dispenser mechanism.
Remove the ice storage bin and shake to loosen the cubes.
NEVER use an ice pick or similar sharp instrument to break up
the ice. This could damage the ice storage bin and dispenser
mechanism.
16