Care, Replacement and, Of filter – Kenmore 758.15408 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Replacement and

Care

of Filter

Grasp housing

WARNING:

To reduce the risk of

shock or injury from moving parts,
always unplug humidifier before
removing or replacing any parts.

CAUTION:

To help retard bacteria

growth and keep maximum efficiency,
the filter should be replaced at least
once per season, or more often
under hard water conditions. Use
Kenmore 32-15508 recommended
replacement filter.

Replace the evaporative wicking filter at
least once per humidification season or
more depending on water conditions in
your area.

Filter Replacement

1. Unplug humidifier. Before removing

the filter, we recommend moving the
humidifier to an area where floor
coverings are not susceptible to water
damage, (i.e. kitchen or bath areas.)

2. Remove the water bottle and set aside.

Be sure not to bump or damage the fill
valve.

3. Grasp the housing assembly and lift

straight up and away from the base
and set aside. The filter is now
accessible.

4. Take note of the filter position.

Remove the filter. You may want to

clean the base at this time. See the
"Cleaning Your Humidifier" section of
this manual.

5. Install a new filter (32-15508) into the

base. Coil the filter and position it
between the uprights in the bottom of
the base. The start and finish of the
coil should be captured at the center
of the base (see diagram) and the

filter should be resting on the floor of
the base.

6. Return the housing assembly to the

top of the base. Reposition the
humidifier to its operating position.

7. The humidifier is now ready to be filled

for operation.

10

Advertising