Kenmore DELUXE 625.3844 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION STEPS (cont.)
PlUy^P HOUSING UNDERSINK TO piuy^p
yQ
qhe
FAUCET
REFER TO PAGE 5. If optional kits are used, follow
instructions included with them.
1. Close the cold water side shutoff valve. (Usually,
there already is a shutoff under the sink. If not, close
the main water shutoff valve near the water meter or
pressure tank.)
2. Cut and remove a section of the cold water pipe.
3. If plumbing with flexible tubing, hang or support
the filter housing in some manner. If using rigid
pipe, be sure to allow a minimum of 1 -1 / 2" clearance
under the filter for sump removal when changing the
filter cartridge.
4. Use the plumbing procedures on page 5 if using
compression fittings. Follow procedures on pages 5
and 6 for sweat copper and threaded pipe installa
tion. Be sure water flow is into the filter inlet side
and from the outlet side to the faucet.
Note: A grounding jumper wire is not required.
5. Before turning on the water supply remove the
sump from the filter head and install the filter car
tridge (see below).
FILTER CARTRIDGE INSTALLATION
TURN TO PAGE 9 AND FOLLOW ALL STEPS UNDER -pipTER CARTRIDGE REPLACEMENr