Kenmore 29052 User Manual
Kenmore, Continued, reverse side), Before operating your washer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Kenmore
OPERATING INSTRUCTIONS
29052
WASH/RINSE TEMPERATURE CYCLE SIGNAL
EXTRA RINSE
FINAL SPIN SPEED
WARM
COLD
COLD
.COLD
HOT
COLD
.WARM
•
warm
LOUD
REGUUUVPEDM PRESS
VES
NORMAL
FAST
Heavy Duty Ш 2 Way Tumble Action • Stainless Steel
О
DOOR
LOCK
raEWASH
HAND
WASHABLES
PERM
PRESS
REGULAR
HEAVY WASH
.WASH
SHORT WASH
FINAÚ
SPIN
mNSEsa SPINS
нанлтияыаоаа/тстозрт
WASH
FINAL
SPIN
niamsr/urr
hjshtostop
Before Operating Your Washer
Read your washer Use and Care Guide.
It has
important safety and warranty information. It also
has many suggestions for best washing results.
A WARNING
I To reduce the risk of fire, electric
shock, or injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS in your washer Use and
Care Guide before operating this appliance.
Operating Steps
Read and follow
Washing Procedures
in your
Use and Care Guide. It provides detailed
information for preparing the wash load and
choosing control settings to ensure best washing
results.
1. Sort laundry into loads that can be washed
together.
2. Prepare items for washing.
Printed in U. S. A.
3. Pretreat stains and heavy soil.
4. Add laundry load to the wash drum.
5. Open the dispenser drawer and add the
measured amount of detergent to the
detergent compartment.
If desired, add liquid
bleach and fabric softener to the appropriate
compartments. Slowly close dispenser drawer.
The washer will not operate with the drawer
open.
6. Set Wash/Rinse Temperature according to
fabric type and soil level of each load.
7. Select desired Cycle Signal volume.
8. If desired, select Extra Rinse in the Regular
or Perm Press cycle.
9. Select Final Spin Speed as desired when
using the Perm Press or Hand Washables
cycles.
10. Push in the cycle selector knob and turn it
clockwise to the desired wash cycle.
11. Start the washer by closing the door and
pulling out the cycle selector knob.
The
washer will
not
operate with the
door
open.
As a safety measure, the
door
wiil
automatically lock during the entire wash
cycle.
•
To stop the washer, push in the cycle
selector knob.
•
To change a cycle, push in the cycle
selector knob and turn it clockwise to the
desired setting.
•
Pull out the knob to restart the washer.
12.
Remove items when cycle ends.
When the
Cycle Signal control is on, a signal will sound
at the end of the cycle.
Note:
From time to time you may see water in
the bleach and fabric softener compartments.
This is a result of the siphoning action and is
part of the normal operation of the washer.
(continued, reverse side)
P/N 131809400 (9812)