Assembly instructions, Tools required for assembly – Kenmore 141.229952 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Assembly Instructions

Before assembling the patio heater, use the parts
list to check that all necessary parts have been
included. Inspect patio heater for damage as you
proceed. Do not assemble or operate the patio
heater if it appears damaged. If you have ques­

tions during the assembly process, call 1-888-317­

7642, 8am - 8pm CST, Monday through Friday.

CAUTION;

While it is possible for one person to assemble
this patio heater, we recommend you have assis­
tance when attaching the Reflector, heater Head

Assembly and threading the stainless Fuel Hose.

Remove all parts and hardware from carton. Refer

to the parts list and hardware pack illustrations
and assemble the patio heater on a protective

work surface to avoid scratching heater surfaces.

1. Unscrew the three 3/8"x1-1/4" Hex Head

Screws from the Weighted Base.

Loosely install the two Legs with Hooks onto

Weighted Base by using 2 of the 3/8" Spring
Washers and the detached 3/8''x1-1/4" Hex

Head Screws. Make sure the Hooks are in

the front for the Safety Chain. See Fig. 1.

Loosely install the third Leg using a 3/8"

Spring Washer and the detached 3/8"x1-1/4"

Hex Head Screw.

2. Hang the Safety Chain on the Hooks of both

Legs.

3. Attach the Lower Post (with bracket) onto the

top of Legs by using 5 of the 3/8"x3/4" Hex

Head Screws, 10 of the 3/8" Spring Washers

and 5 of the 3/8" Cap Nuts in sequence as
shown in Fig. 2. Use adjustable wrench to
tighten the Nuts.

4. Secure Hose Holder A to the right Leg using

1 of the 3/8"x3/4" Hex Head Screw, 2 of the

3/8" Spring Washers and 1 of the 3/8" Cap

Nut. See Fig. 2. Use adjustable wrench to

tighten the Nut.

5. Tighten the loosely attached screws from

Steps 1, 3 and 4.

6. Straighten the Corrugated Stainless Steel Fuel

Hose and insert it through the Upper Post as

shown in Fig. 3.

With another person holding the Upper Post
upright, attach the Heater Head Assembly to

the top of Upper Post using 4 of the T4x15

Self-Tapping Screws provided.

Tools Required for Assembly

• Protective gloves
• Eye protection
• One #2 Phillips Head Screwdriver
• Two Adjustable Wrenches

Figure 1

3/8"x1-1/4" HEX HEAD SCREW DETACHED

FOR LEG INSTALLATION

Figure 3

HEATER HEAD

INSIDE

10

Advertising